carriage driver_hold_gain hgain All Carriage stepper motor current applied when stationary and holding position. This is the carriage's normal state when stopped. Normally, this parameter should not be changed from the factory default. Setting this current too high will lead to the carriage overheating. Setting this current too low may cause the carriage to lose accuracy. integer
  • 60
    •
  • 0 to 254
    •      cal
  • ../nvs/carriage_cal_mgain.xmlNVS: carriage mgain
  • ../nvs/carriage_cal_again.xmlNVS: carriage again
  • ../nvs/carriage_cal_pgain.xmlNVS: carriage pgain
    •
  • ..\..\ShowAllErrors.htmFirmware 0 Error Index
  • ..\..\ShowAllCommands.htmFirmware 0 Command Index
  • ..\..\ShowAllNVS.htmFirmware 0 NVS Index
    •  Updated: Wed Jul 16 19:36:40 2008 PST